Bullet R1 Induction PCB Module
Bullet R1 Induction PCB Module

Bullet R1 Induction PCB Module

$440.00
Shipping calculated at checkout.

110v Induction PCB Module for the Aillio Bullet R1 V2. This is the large module located on the underside of the Bullet, protected by the PCB Cover.

 

See full compatiblity details in the Overview section below.
Product Overview
Product Overview

Compatible with R1 v2 models. Units with older serial numbers (roughly S/N 4673 and down) were manufactured with a different version of the Induction Module and Power PCB Cover, the latter of which was completely flat on the bottom side. The newest PCB Covers have a small hump that protrudes out of the bottom side, allowing extra room for the updated Induction Module. If you have an outdated version the Power PCB Cover, you'll need to swap it out for a the new version when installing a new Induction Module. Check out the updated Power PCB Cover Set here.

 

After installation, you will need to recalibrate your Bullet's exhaust fan impeller. Navigate to the Use & Care tab for a link to a video demonstration from Aillio.

Use & Care
USE & CARE

Removing Bullet Legs Video from Aillio

Induction Module Installation Video from Aillio

Bullet Legs Reinstallation Video from Aillio

Exhaust Fan Impeller Calibration Guide from Aillio. Calibration must be completed after installing a new Induction Module.

Reviews

NEW PRODUCT ARRIVALS